CyckelLjudet – Attaching electronics and solar panels

IMG_0012
All pimped out and ready for the west pride parade Regnbågsparaden!

IMG_0010 IMG_0009
To be able to drive the amplifier for the speaker we use an UPS. On top of the UPS you can see the solar regulator Solar80.
The solar regulator is charging a 6S 8Ah LiPo battery pack. The solar panels will generate maximum of 600W of power, and the PA-system will draw about 65W of power, so the battery will be more of a buffer.

IMG_0011
After some spec-readings we realized that the Solar80 wouldn’t handle the maximum of 70V that the solar panels could generate, it only supported 48V. So we switched it out for Flexmax 80.
Both the controllers were designed for lead-acid battery’s and not for LiPo battery’s. I was missing a parameter to set the charge voltage, also there was software limitations that you couldn’t go around, like the charging current for example, you could only go as low as 5A.
We’re trying out the solar panels and solar regulator in the sun charging the LiPo. The stop-charing-limit was set to 25.2V which is the voltage of a maximum charged LiPo, but the solar regulator was still inputing voltage well above 25.2V because the solar regulator is designed for lead acid battery’s. We then set the maximum-charging-voltage to 24.8V that seemed to help, the voltage over the battery didn’t reached over 25.2V.

IMG_0008
Cables from the solar panels.

IMG_0007 IMG_0006
Amplifier/mixer in place, and so is the LED-bars.

IMG_0005 IMG_0004 IMG_0003 IMG_0002 IMG_0001 IMG_5570 IMG_5568 IMG_5565 IMG_5563

Comments are closed.